Go to…

Dodge

Home / Dodge / Page 3

We Service and Repair all Dodge cars

  • 2004 Dodge Pickup

    Dodge Pickup
    Mileage
    246,814
    Service Date
    10/5/2020
    Services Performed
    • A/C COMPRESSOR – Remove & Replace – In-Line6 – [DOES NOT include Air Conditioning System recover, evacuate and/or recharge.]
    • THERMOSTAT &/OR GASKET – Remove & Replace – In-Line6 w/Air Cond
    • TRANSMISSION OIL COOLER – Remove & Replace – Diesel Air To Oil,Front of Radiator
    • WATER PUMP – Remove & Replace – In-Line6
     
    NATE P. gave our service a 5 star review on 10/5/2020

  • 2006 Dodge Pickup

    Dodge Pickup
    Mileage
    264,549
    Service Date
    6/19/2020
    Services Performed
    • BALL JOINT – Remove & Replace – R2500,R3500,4WD Upper & Lower,Both Sides – [Includes: R&I Steering Knuckles.] – [DOES NOT include alignment.]
    • CENTER LINK – Remove & Replace – R2500,R3500,4WD – [DOES NOT include alignment.]
    • DRAG LINK – Remove & Replace – R2500,R3500,4WD – [DOES NOT include alignment.]
    • FUEL INJECTOR – Remove & Replace – 5.9L Eng All
    • FUEL PUMP – Remove & Replace – Diesel Engine,High Pressure
    • POWER STEERING PUMP – Remove & Replace – Diesel – [Includes: Test.]
    • TIE ROD &/OR END – Remove & Replace – R2500,R3500,4WD One – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some m
    • ALLINGMENT
    • INJECTOR FLOW TEST SEATTLE INJECTION
    • SHIPPING
     
    OATES C. gave our service a 5 star review on 6/28/2020

  • 2006 Dodge Pickup

    Dodge Pickup
    Mileage
    259,233
    Service Date
    3/13/2020
    Services Performed
    • (Combination) – UNIVERSAL JOINT – Remove & Replace Each
    • (Combination) – UNIVERSAL JOINT – Remove & Replace R2500,R3500 BOTH
    • AXLE SHAFT ASSEMBLY – Remove & Install or Remove & Replace – R2500,R3500 Both Sides
    • BRAKE SHOES &/OR PADS – Remove & Replace – Front – [Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.]
    • CALIPER – Remove & Replace – Both,Front or Rear – [Includes: Bleed System and replace Pads (if necessary).]
    • CENTER LINK – Remove & Replace – R2500,R3500,4WD – [DOES NOT include alignment.]
    • DISC ROTOR – Remove & Replace – 4WD Front,8 Lug,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing. Includes: Replace Pads (if necessary). DOES NOT include refinishing.]
    • DRAG LINK – Remove & Replace – R2500,R3500,4WD – [DOES NOT include alignment.]
    • INSTALL DUAL STEERING DAMPENER
    • PITMAN ARM – Remove & Replace – R2500,R3500,4WD – [DOES NOT include alignment.]
    • PROPELLER SHAFT – Remove & Install or Remove & Replace – Two Piece Driveline,To Rear Axle,Front,Shaft
    • TIE ROD &/OR END – Remove & Replace – R2500,R3500,4WD One – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inner Tie Rod End(s) on some m
    • TRACK BAR – Remove & Replace – All Applicable Models
    • ALIGNMENT
    • SHIPPING
     
    EDWARD W. gave our service a 5 star review on 3/13/2020